Before you start
Use a metal tape measure, a pencil and a sheet of paper, or the notes on your phone. Measure in millimetres: 2400, not 2.4 m or 240 cm. A second person to hold the other end of the tape makes long walls easier and more accurate.
1. Sketch the room from above
Draw the walls as a simple outline from above, with every door, window, opening and corner. It does not need to be to scale. Give each wall a letter, A, B, C, going around the room from left to right: our design tool uses the same letters, so your notes will match it.
2. Measure each wall
Measure every wall from corner to corner three times: just above the floor, at bench height (about 900 mm off the floor) and near the ceiling. Walls are rarely perfectly straight, so the numbers often differ by a few millimetres. Write them all down; the cabinets are planned to the smallest one.
Measure along the wall itself, not along the front of the old cabinets, and include the part of the wall hidden behind the fridge.
3. Measure the height
Measure from the floor to the ceiling at both ends of each wall and in the middle. Note any bulkhead, sloping ceiling or beam, and how far it comes down. If new floor tiles or boards are going in, say so: the heights are measured from the finished floor.
4. Mark the windows and doors
For each window and door, measure from the nearest corner to the outside edge of its frame (the architrave), then the width across the frames. For windows, also measure from the floor to the sill. Note which way each door swings, so no cabinet stops it opening.
5. Find the services
Mark where the water pipes and the sink waste come out of the wall or floor, the power points and switches, the gas point for a gas cooktop, and the rangehood duct if there is one. Measure each one from the nearest corner and from the floor. Moving them is work for a plumber, electrician or gas fitter, so it helps to know early whether the new layout keeps them where they are.
6. Write down the appliances
Note the brand and model number of the fridge, oven, cooktop, rangehood, dishwasher and microwave you will use, new or old. Every maker publishes the size of the space its appliance needs, including the gaps for air around a fridge or a built-in oven. Cabinets are made around those spaces, so model numbers are worth more than a rough width.
7. Check the corners
Corners are not always square. To check one, measure 300 mm along one wall from the corner and make a mark, then 400 mm along the other wall and make a mark. If the corner is square, the distance between the two marks is exactly 500 mm. A few millimetres out is normal; more than that is worth writing down.
Replacing old cabinets
Measure the room, not the old cabinets. Old kitchens often hide floors that are out of level, patched walls and pipes in odd places, and new appliances may not be the same size as the old ones. If you are keeping the old benchtop or any appliances, say so and measure them too.
What happens next
Put your sizes into the design tool. Rough sizes are enough to ask for a price for a new kitchen or any other room, and every size is checked with you before anything is cut.
